PLE forum

Full Version: Corrosion allowance and fabrication tolerance of a tee
You're currently viewing a stripped down version of our content. View the full version with proper formatting.
Ple4Win assumes that the corrosion allowance and fabrication tolerance of a tee has the same values as the matching pipes.
Often this is not the case.

I know it is also possible to give a higher tolerance and corrosion allowance in the WALL table.

Giving a lower value for the T-RUN and T-BRN will give different SIF factors.

Is it possible to extend the TEESPEC table with the corrosion and fabrication tolerance?
Thank you for your input.

We have noted your request. I have no idea yet what the implications of your request are, but we will discuss it with our team.