PLE forum
Bug: Zoomed in too far! Please zoom out... - Printable Version

+- PLE forum (http://www.ple4win.nl/forum)
+-- Forum: Support (http://www.ple4win.nl/forum/forumdisplay.php?fid=5)
+--- Forum: Ple4Win User Interface (http://www.ple4win.nl/forum/forumdisplay.php?fid=29)
+--- Thread: Bug: Zoomed in too far! Please zoom out... (/showthread.php?tid=261)



Bug: Zoomed in too far! Please zoom out... - shaswin - 28-04-2012

Affected version: Ple4Win 4.2.0
Reproducible: Always

This bug is related to bug http://www.rkconsult.nl/forum/showthread.php?tid=163http://www.rkconsult.nl/forum/showthread.php?tid=163 , but without any WEAK elements in it.

[attachment=289]

Steps to reproduce the issue:
Step 1: Open bc.plexe with the Educational version of Ple4Win (see attached file);
Step 2: Go to DF6.2 and go to output table CSTRMAX;
Step 3: Select column ELEM first and then column MISES-M using the Ctrl key and view the Single Graph by clicking on the "Show SingleGraph" button. Don't close the graph;
Step 4: Go to DF2 and set back this function;
Step 5: Go to POLYDIF and click on "insert emty row(s)" button, so that one row is added before Identifier p1;
Step 6: Write the following values:
IDENT: leave it empty
DX-N: 1000
DX-Y: 1000
Z-N: 0
BENDRAD: 0
ETYP: leave it empty
BEND_EL: leave it empty
PIPE_EL: 200
EXT: leave it empty

Step 7: Click on the "Process" button on the roadmap (without testing the table);
Step 8: Go to DF6.2 and go to output table CSTRMAX;
Step 9: Select column ELEM first and then column MISES-M using the Ctrl key and view the Single Graph by clicking on the "Show SingleGraph" button.

After step 9 you will get the message "Zoomed in too far! Please zoom out..." in the Single Graph.


RE: Bug: Zoomed in too far! Please zoom out... - shaswin - 31-05-2012

Jens, did you have reproduced this issue?


RE: Bug: Zoomed in too far! Please zoom out... - P Herwig MSc - 24-03-2016

Solved in the mean time as it is no longer reproducable.