PLE forum
Extending DEADW input table with 2 extra columns - Printable Version

+- PLE forum (http://www.ple4win.nl/forum)
+-- Forum: Support (http://www.ple4win.nl/forum/forumdisplay.php?fid=5)
+--- Forum: Ple4Win User Interface (http://www.ple4win.nl/forum/forumdisplay.php?fid=29)
+---- Forum: Suggestions and Feedback (http://www.ple4win.nl/forum/forumdisplay.php?fid=10)
+----- Forum: Wish List (http://www.ple4win.nl/forum/forumdisplay.php?fid=21)
+----- Thread: Extending DEADW input table with 2 extra columns (/showthread.php?tid=270)



Extending DEADW input table with 2 extra columns - shaswin - 22-05-2012

When the W-LEVEL is set on YES and you have a discontinuty in your WALL table you can't use the IDENTifiers. You have to use AX-L, AX-LP, NODE or ELEM for the toggling state. This is not user-friendly when your configuration changes in the POLYDIF.

There is space in the DEADW input table for a DEADW-3 and DEADW-4 column:
DEADW-1 - deadweight pipeline part under water level left of the node (identifier);
DEADW-2 - deadweight pipeline part above water level left of the node (identifier);
DEADW-3 - deadweight pipeline part under water level right of the node (identifier);
DEADW-4 - deadweight pipeline part above water level right of the node (identifier);
W-LEVEL = YES

If W-LEVEL is empty or set on NO then DEADW-3 and DEADW4 should be empty:
DEADW-1 - deadweight pipeline part under or above water level left of the node (identifier);
DEADW-2 - deadweight pipeline part under or above water level right of the node (identifier);
W-LEVEL = NO or empty


RE: Extending DEADW input table with 2 extra columns - Dr. J Foerster - 30-05-2012

You are correct, currently you can either use DEADW1 and DEADW2 to define a jump in deadweight, or use DEADW1 and DEADW1 to define the situation above and below water, but not both situations together.
We filed this request as ticket no. 1128.


RE: Extending DEADW input table with 2 extra columns - shaswin - 29-07-2013

Jens,

Can you give this wish more priority then my other wishes.
Is it possible to implement this in the next release?

Thanx


RE: Extending DEADW input table with 2 extra columns - Dr. J Foerster - 20-08-2013

I will discuss it here, but there are quite a lot of underlying problems involved if we want to implement this request.

So no promises Confused


RE: Extending DEADW input table with 2 extra columns - shaswin - 21-08-2013

Another way is to allow duplicate IDENTIFIER names near each other to simulate the jump. The error shouldn't be displayed. The error should only be displayed when the IDENTIFIERS are not in increasing order.

This is then also backwards compatible with the older version of Ple4Win. The dimensions of the DEADW table would be the same.


RE: Extending DEADW input table with 2 extra columns - Dr. J Foerster - 13-09-2013

You can always put two IDENTS close to each other in the POLYDIF table (or ADDIDENT) and approximate the jump by a very steep slope.