PLE forum
Bug Function stopped due to occurring errors - Printable Version

+- PLE forum (http://www.ple4win.nl/forum)
+-- Forum: Support (http://www.ple4win.nl/forum/forumdisplay.php?fid=5)
+--- Forum: Ple4Win User Interface (http://www.ple4win.nl/forum/forumdisplay.php?fid=29)
+--- Thread: Bug Function stopped due to occurring errors (/showthread.php?tid=552)



Bug Function stopped due to occurring errors - shaswin - 25-08-2016

Affected version: Ple4Win Professional v4.4.0 build 16050 rev. 26 may 2016
This bug is always reproducible.

[attachment=827]

Steps to reproduce this bug:
Step 1: Run the attached project file till DF6.2;
Step 2: Save the project file by clicking on the 'Save the project'-button. This is important. If you don't do this the bug will not occur;
Setp 3: Set Back to DF 4.2;
Step 4: Clear the whole SETZ input table by clicking on the 'Remove all data from table'-button;
Step 5: Run the project again till DF6.2.

You will see that the bug will occur during the end of the element calculations in DF6.2 leaving the project file in a damaged situation.


RE: Bug Function stopped due to occurring errors - P Herwig MSc - 25-08-2016

Shaswin, thanks for reporting. I was able to reproduce this phenomenon and assigned ticket J-1915 to it.