PLE forum
Horizontal and vertical scaling Pipeline Overview - Printable Version

+- PLE forum (http://www.ple4win.nl/forum)
+-- Forum: Support (http://www.ple4win.nl/forum/forumdisplay.php?fid=5)
+--- Forum: Ple4Win User Interface (http://www.ple4win.nl/forum/forumdisplay.php?fid=29)
+---- Forum: Suggestions and Feedback (http://www.ple4win.nl/forum/forumdisplay.php?fid=10)
+----- Forum: Wish List (http://www.ple4win.nl/forum/forumdisplay.php?fid=21)
+----- Thread: Horizontal and vertical scaling Pipeline Overview (/showthread.php?tid=574)



Horizontal and vertical scaling Pipeline Overview - shaswin - 10-06-2017

Hello,

Is it possible to add an extra checkbox in the Pipeline Overview panel for using the same scale for the horizontal and vertical plane, so that for example the arc length of a bend is drawn in the same scale in the selected horizontal and vertical plane in the Pipeline Overview.

See example below; you see that the horizontal plane is stretched too much in relation with the vertical plane.

[attachment=880]

Thanks


RE: Horizontal and vertical scaling Pipeline Overview - Dr. J Foerster - 12-07-2017

I am sorry, I do not think I understand this request. The pipeline drawing is always shown with the same scaling factor along the x- and the y-axis.

In the picture you supplied, I inserted a rectangle with a height and width of 250 mm according to each of the axes. As you can see it is a perfect square, so horizontal and vertical axes are drawn at the same scale.
[attachment=881]


RE: Horizontal and vertical scaling Pipeline Overview - shaswin - 13-07-2017

Thanks for the explaination.