• 0 Vote(s) - 0 Average
• 1
• 2
• 3
• 4
• 5
45 degree connections
22-12-2011, 10:52 AM, (This post was last modified: 22-12-2011, 04:40 PM by peipei.)
 peipei Junior Member Posts: 17 Threads: 14 Joined: Dec 2011 Reputation: 0
45 degree connections
Dear Mr./Mrs.
I have two questions about connections.
We are now busy with a project which has a lot of 45 degree reinforced connections. After reading the document of “T-stukken in PLE-micro-CAD” rev.7 d.d.1-11-2002, it is possible to do it for the configuration.
But according to the explanation, in the T-module it is combined with Stress intensification factor (SIF) of in and out-plane

In the Tee

However, without T-module we have to input the SXUB1 factor in table CSWEIGH. From what I understand is that
• If PHI-MB is 90 or 270 degree, then Mbi=0, MBEN=Mbo. In this case SXUB1=SIX-OP
• If PHI-MB is 180 or 360 degree, then Mbo=0, MBEN=Mbi. In this case SXUB1=SIX-IP
Question 1:
If PHI-MB is not the case above, how could I combine SIX-OP and SIX-IP to SXUB1?
Question 2:
What is the Stress intensification factor for 45 degree?

12-08-2014, 04:14 PM, (This post was last modified: 12-08-2014, 04:16 PM by shaswin.)
 shaswin Senior Member Posts: 369 Threads: 192 Joined: Dec 2008 Reputation: 0
RE: 45 degree connections
Jens,

Is it possible to extent the helpfile with the important PLE document “T-stukken in PLE-micro-CAD” rev.7 d.d. 1-11-2002

This old document, but still important document, is no longer online available on the PLE website.

Thank you.
09-05-2016, 11:39 PM,
 Bas Junior Member Posts: 12 Threads: 7 Joined: Aug 2014 Reputation: 0
RE: 45 degree connections
Is the PLE document “T-stukken in PLE-micro-CAD” still available?
10-05-2016, 06:54 AM, (This post was last modified: 10-05-2016, 06:55 AM by shaswin.)
 shaswin Senior Member Posts: 369 Threads: 192 Joined: Dec 2008 Reputation: 0
RE: 45 degree connections
(09-05-2016, 11:39 PM)Bas Wrote: Is the PLE document “T-stukken in PLE-micro-CAD” still available?

I have added a scanned version of the analog version I had. I no longer have the original PDF file.
Note that in Ple4Win Professional v4.3.1 the SIF factors of the Tees (90 degrees) has been changed:

Attached Files
T-stukken in PLE-micro-CAD (gescand).pdf (Size: 1.41 MB / Downloads: 4)
10-05-2016, 07:17 AM, (This post was last modified: 10-05-2016, 07:17 AM by Bas.)
 Bas Junior Member Posts: 12 Threads: 7 Joined: Aug 2014 Reputation: 0
RE: 45 degree connections
Thanks Shaswin!

Forum Jump:

Users browsing this thread: 1 Guest(s)