This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
No supports possible in inclined parts of the pipeline
24-03-2016, 10:55 AM,
#3
RE: No supports possible in inclined parts of the pipeline
As from version 4.2.0 no error is given for a support at a steep slope. However warning W330/3 is written to the Warning table to indicate the vertical angle of the pipeline at the position of the support, defined in the local coordinate system, is greater than 20 degrees.


Messages In This Thread
RE: No supports possible in inclined parts of the pipeline - by P Herwig MSc - 24-03-2016, 10:55 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)