This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
No supports possible in inclined parts of the pipeline
19-07-2011, 09:30 PM, (This post was last modified: 20-07-2011, 08:43 AM by shaswin.)
#1
No supports possible in inclined parts of the pipeline
When you have a support in the inclined part of the pipeline (with an angle let say for example 30 degrees) an error will occur. Ple4Win doesn't allow supports in the inclined parts with high angles. The function will be stopped.

This warning will be given:

   

Why do you give this error?

Theoretically it is possible to calculate support forces in an inclined part of a beam.


Messages In This Thread
No supports possible in inclined parts of the pipeline - by shaswin - 19-07-2011, 09:30 PM
RE: No supports possible in inclined parts of the pipeline - by P Herwig MSc - 24-03-2016, 10:55 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)