This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
45 degree connections
22-12-2011, 10:52 AM, (This post was last modified: 22-12-2011, 04:40 PM by peipei.)
#1
45 degree connections
Dear Mr./Mrs.
I have two questions about connections.
We are now busy with a project which has a lot of 45 degree reinforced connections. After reading the document of “T-stukken in PLE-micro-CAD” rev.7 d.d.1-11-2002, it is possible to do it for the configuration.
But according to the explanation, in the T-module it is combined with Stress intensification factor (SIF) of in and out-plane
   
In the Tee
   
However, without T-module we have to input the SXUB1 factor in table CSWEIGH. From what I understand is that
• If PHI-MB is 90 or 270 degree, then Mbi=0, MBEN=Mbo. In this case SXUB1=SIX-OP
• If PHI-MB is 180 or 360 degree, then Mbo=0, MBEN=Mbi. In this case SXUB1=SIX-IP
Question 1:
If PHI-MB is not the case above, how could I combine SIX-OP and SIX-IP to SXUB1?
Question 2:
What is the Stress intensification factor for 45 degree?
   
Reply


Messages In This Thread
45 degree connections - by peipei - 22-12-2011, 10:52 AM
RE: 45 degree connections - by shaswin - 12-08-2014, 04:14 PM
RE: 45 degree connections - by Bas - 09-05-2016, 11:39 PM
RE: 45 degree connections - by shaswin - 10-05-2016, 06:54 AM
RE: 45 degree connections - by Bas - 10-05-2016, 07:17 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)