This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Single Graph is not complete when overloop error occurs
11-01-2012, 01:49 PM, (This post was last modified: 11-01-2012, 01:57 PM by shaswin.)
#1
Single Graph is not complete when overloop error occurs
Affected version: 4.1.2

When you have a large systemlength with small elements lengths an overloop error may occur.

The single graph won't show the complete stress picture. The last part of the stress picture is missing.

   

Workaround:
You have to close Ple4Win completely and open Ple4Win and view the single graph again. This overloop error will not show then and the single graph will be complete.


Messages In This Thread
Single Graph is not complete when overloop error occurs - by shaswin - 11-01-2012, 01:49 PM
RE: Single Graph is not complete when overloop error occurs - by P Herwig MSc - 24-03-2016, 02:44 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)