This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Single Graph is not complete when overloop error occurs
08-05-2012, 02:28 AM, (This post was last modified: 08-05-2012, 07:35 AM by shaswin.)
#5
RE: Single Graph is not complete when overloop error occurs
I can reproduce the issue in the latest Educational version (version v4.2.0) in a different polyline configuration, so that the stress picture is not complete.

Steps to reproduce the issue:
Step 1: Open bc.plexe with the Educational version of Ple4Win (see attached file);
Step 2: Go to DF6.2 and go to output table CSTRMAX;
Step 3: Select column ELEM first and then column MISES-M using the Ctrl key and view the Single Graph by clicking on the "Show SingleGraph" button. Don't close the graph;
Step 4: Go to DF2 and set back this function;
Step 5: Go to POLYDIF input table and change all PIPE_ELem lengths from 200 to 100 mm;
Step 6: Click on the "Process" button on the roadmap (without testing the table);
Step 7: Go to DF6.2 and go to output table CSTRMAX;
Step 8: Select column ELEM first and then column MISES-M using the Ctrl key and view the Single Graph by clicking on the "Show SingleGraph" button.

After step 8 you will get the message "Zoomed in too far! Please zoom out..." in the Single Graph. The stress Single Graph is now not complete! The stresses are viewable from ELEM 1 till ELEM 23 (AX-L 50 mm till 2050 mm). The stresses for ELEM 24 till ELEM 43 are missing in the stress Single Graph. This issue is related with the first post (screenshot from the professional version 4.1.2), but only the text in the horizontal bar is different now.

By the way, did you change the text "Overloopfout." into "Zoomed in too far! Please zoom out..." in the latest Ple4Win version 4.2.0. If so, then the bug has been reproduced, otherwise this is a different, but a related bug.

This bug is also reproduced in the professional version v4.2.0.


Attached Files
.zip   bc.zip (Size: 170.86 KB / Downloads: 0)


Messages In This Thread
RE: Single Graph is not complete when overloop error occurs - by shaswin - 08-05-2012, 02:28 AM
RE: Single Graph is not complete when overloop error occurs - by P Herwig MSc - 24-03-2016, 02:44 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)