This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Calculation of element(s) not successful
19-01-2015, 12:32 PM,
#7
RE: Calculation of element(s) not successful
Hello Jens,

This issue still exists in the latest Ple4Win version 4.3.0 build 14120.

I can reproduce the issue now. I have attached an example project file where this issue occurs.

Steps to reproduce the issue:
Step 1: Open 'Limit State B.1 (inwendige druk).plex' which is attached in this post;
Step 2: Set Back in the roadmap to DF4.2 (Pipeline Loading);
Step 3: Go to SETZ and insert the following data for example:
   
Step 4: Run the project from the roadmap process button without testing the table SETZ;
Step 5: When DF 6.2 is finished click on the 'Save the project' button on the toolbar;
Step 6: Set Back in the roadmap to DF4.2 (Pipeline Loading);
Step 7: Clear the whole SETZ table with the 'Remove all data from table' button from the toolbar in the workspace panel;
Step 8: Run the project from the roadmap process button.

Step 8 will never be finished, because of this error:
   
Look now in table RDPLMAX:
   


Attached Files
.zip   Limit State B.1 (inwendige druk).zip (Size: 1,008.07 KB / Downloads: 4)
Reply


Messages In This Thread
RE: Calculation of element(s) not successful - by shaswin - 19-01-2015, 12:32 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)