This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Calculation of element(s) not successful
08-05-2012, 01:01 PM, (This post was last modified: 31-07-2013, 10:24 PM by shaswin.)
#1
Calculation of element(s) not successful
Affected version: Ple4Win v4.2.0
Reproducible: It cannot be reproduced always.

I am trying to do a calculation, but Ple4Win stops the calculation unexpectedly.
NaN values are generated in all output tables in DF6.2, see printscreen below.

   

The following warning message will appear in the warning table.

   

Jens, I have sent you the project file, so you can debug it.

This happened a few times in the latest version of Ple4Win (v4.2.0), but didn't occure in the earlier versions of Ple4Win.
The few times the calculation failed in DF6.2 was when the NEN check analysis mode was selected in DF1.

After a Set Back to DF6.1 the calculation in DF6.2 will be correct again when you hit the process button on the roadmap.
Reply


Messages In This Thread
Calculation of element(s) not successful - by shaswin - 08-05-2012, 01:01 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)