This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Incorrect error E500/96 in NEN 3650 Analysis Type mode
07-05-2013, 04:22 PM, (This post was last modified: 07-05-2013, 04:25 PM by shaswin.)
#1
Incorrect error E500/96 in NEN 3650 Analysis Type mode
Version: Ple4Win Professional version 4.2.2 build 12120

I am getting an error when I want to do a calculation in the NEN 3650 analysis type mode. The Q-module isn't normally available in this analysis type. The key I used doesn't has the Q-module. According to the printscreen below I am doing a Non-Lineair calculation with a Non-Ovalising section model (so no Q-module is needed).
   

I don't understand this warning:
   

According to the helpfile this is the case:
   

I will sent the project file for further analysis to info@eds-ple.nl


Messages In This Thread
Incorrect error E500/96 in NEN 3650 Analysis Type mode - by shaswin - 07-05-2013, 04:22 PM
RE: Incorrect error E500/96 in NEN 3650 Analysis Type mode - by P Herwig MSc - 17-03-2016, 03:06 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)