This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
About Deadweight
04-07-2013, 01:54 PM,
#1
About Deadweight
Hi,

May I ask that why in Ple4win the user have to fill the deadweight? If the water level, diameter, thickness, material are already known, is it possible the software calcultate automatically?

Since I am calculating a huge configuration in PLE4Win with diverse diameter and thickness. It really takes a lot of time to fill in the deadweight, especially the water level is present and each time when there is the jump of deadweight.

If the deadweight could be calculated automatically it will save a lot time in such case.

regards,
Reply


Messages In This Thread
About Deadweight - by peipei - 04-07-2013, 01:54 PM
RE: About Deadweight - by Dr. J Foerster - 05-07-2013, 11:25 AM
RE: About Deadweight - by peipei - 05-07-2013, 11:34 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)