This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
LOCASE in Fuction 5
17-03-2014, 02:20 PM,
#1
LOCASE in Fuction 5
Hi,

I have a case which is connected by PVC pipe and Steel pipe. In this case all the loading factor for PVC according to NEN3650-3 should be 1,0 and the loading factor for steel is not the case according to NEN3650-2.

But I could not add one extra line to the LOCASE since the number of rows is fixed to 1. Is it possible to apply the SWEIGH form to LOCASE, by which I could set two different loading factors to different pipe sections.

Regards,
Peipei Dong
Reply


Messages In This Thread
LOCASE in Fuction 5 - by peipei - 17-03-2014, 02:20 PM
RE: LOCASE in Fuction 5 - by Dr. J Foerster - 18-03-2014, 05:15 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)