This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
SWEIGH factors for cast iron ("gietijzer")
07-05-2014, 10:02 AM,
#1
SWEIGH factors for cast iron ("gietijzer")
As an addition to the question about SWEIGH factors for PE: If materials have different factors for axial and tangential directions (such as nodular cast iron) then the following should be applied:

The axial factor should be used for SXUB1, SXUBH, SXIOSH and SXIORA,
the tangential factor should be used for SFIOSH and SFIORA,
all other factors should be set to 1.


Messages In This Thread
SWEIGH factors for cast iron ("gietijzer") - by Dr. J Foerster - 07-05-2014, 10:02 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)