This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
To save the detailed stresses, deformations, strains
26-01-2015, 07:52 PM, (This post was last modified: 26-01-2015, 07:53 PM by shaswin.)
#1
To save the detailed stresses, deformations, strains
Currently the Visualisation module only supports of the visualisation of the max/min value in an element. Is it possible to save every 7.5 degrees the calculated results, so that the visualisation is more realistic. I know that the project file will increase in file size.
Reply


Messages In This Thread
To save the detailed stresses, deformations, strains - by shaswin - 26-01-2015, 07:52 PM
RE: To save the detailed stresses, deformations, strains - by P Herwig MSc - 26-01-2015, 08:05 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)