This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Diameter transition should increase by degrees in the Visualisation module
09-02-2015, 09:52 AM,
#1
Diameter transition should increase by degrees in the Visualisation module
Version: Ple4Win v4.3.0

In the 3D visualisation the pipeline transition from a diameter from 406,4 mm to 219,1 mm is splitted into multiple disconinue jumps over the elements in the transition (depending of the element lengths), see printscreen below.

   

It should increase by degrees ('geleidelijk'). It doesn't look realistic here.

Discontinuity of the diameter should only be visible when you have discontinue diameter (DOUT1 and DOUT2 filled in the same row).


Messages In This Thread
Diameter transition should increase by degrees in the Visualisation module - by shaswin - 09-02-2015, 09:52 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)