This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Horizontal support angle
10-03-2015, 12:33 PM, (This post was last modified: 09-06-2015, 07:35 PM by shaswin.)
#1
Horizontal support angle
Ple4Win uses by default a horizontal support angle of 120 degrees for a single pipe. This angle is hardcoded in the source code and is not available for the user to change this value to for example to 30 degrees in the case of a multiple combined pipes, see article 8.6.3.4 of the Dutch NEN 3651:2012. If the horizontal support is supported by a pipe the contact angle is 30 degrees according to the code.
Ple4Win uses the same angle on both sides.

This horizontal support angle is used in combination with the tables LAMBDA and SOILSUP. A wish is to move the angle 120 degrees and put it in the SUPANG input table. By default the value should be 120 degrees when the defualt button is clicked on. It will have effect on the momentcoefficients, see for the calculation of the momentcoeffficients the book 'Geo-Tubomechanica'.

See also here for the wish list.
Reply


Messages In This Thread
Horizontal support angle - by shaswin - 10-03-2015, 12:33 PM
RE: Horizontal support angle - by Dr. J Foerster - 11-06-2015, 03:08 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)