This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Issue 'Idents not increasing warning'
23-03-2015, 03:12 PM, (This post was last modified: 25-03-2015, 08:45 PM by shaswin.)
Issue 'Idents not increasing warning'
Affected version: Ple4Win Professional v4.3.0 build 14120

When you have for example two Identifiers on the same node a W320/96 warning is given. In this case you have two bends connecting exactly with each other, see printscreens below.

IDENTS table:

WARNING table:

This warning should not be given if the node number is the same. I have attached an example project file.
One would think that something is wrong with the configuration model, which is not the case here.

Attached Files
.zip   BC3 - ambiënt (GENERAL).zip (Size: 2.35 MB / Downloads: 1)

Messages In This Thread
Issue 'Idents not increasing warning' - by shaswin - 23-03-2015, 03:12 PM

Forum Jump:

Users browsing this thread: 1 Guest(s)