This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Membrane stresses check might not be correct in Ple4Win
15-04-2016, 07:25 PM, (This post was last modified: 18-04-2016, 09:14 AM by shaswin.)
#1
Membrane stresses check might not be correct in Ple4Win
In Ple4Win 4.3.1 the membrane stresses check is might not be correct in Ple4Win. According to NEN 3650-2:2012 paragraph 3.1.3 ReT should be used instead of Re.
In table 3 of NEN 3650-2 Re is used instead of ReT, but this is not correct I think, because ReT is lower and can occur in the hot pipeline system. The reference to D.3.1.4 is also not correct in table 3; it should be D.3.1.3. I have contacted with NEN about this issue.

Sv;pm/Re-M might be changed into Sv;pm/ReT-M

   
Reply


Messages In This Thread
Membrane stresses check might not be correct in Ple4Win - by shaswin - 15-04-2016, 07:25 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)