This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.
PLE forum › Support › Ple4Win Calculation
Membrane stresses check might not be correct in Ple4Win

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Thread Modes
Membrane stresses check might not be correct in Ple4Win
10-05-2016, 01:53 PM,
#3
shaswin Offline
Senior Member
****
 		Posts: 346
Threads: 183
Joined: Dec 2008
Reputation: 0
RE: Membrane stresses check might not be correct in Ple4Win
Hello Rien,

You right about that the temprature does not exist in BC 2 + BC 3. But if you were applying BC 2 + BC 3 according to the NEN 3650-2:2003 the temperature was included; this paragraph is not changed after 2003. However we do sometime calculate hotwater pipelines in BC 3 with temperature, because this situation can occur.
I have asked a month ago the question to the NEN committee. They will discuss this issue.
Find
Reply


Messages In This Thread
RE: Membrane stresses check might not be correct in Ple4Win - by shaswin - 10-05-2016, 01:53 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)