This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
SIS input tables active in DF2 without the H module
26-04-2016, 11:13 AM,
#2
RE: SIS input tables active in DF2 without the H module
This is indeed strange! I re-checked, and it appears that your observation is correct. The SIS-input tables are available, which should not be the case.

Note however, that you still can't use SIS without the H module. If you enter data in SISSECT, DF2 can not be calculated. If you enter data in SISPRC only, that data will be ignored. In both cases an error or a warning is reported in the Warnings-table.

I assigned ticket no. J-1876 to this issue.


Messages In This Thread
RE: SIS input tables active in DF2 without the H module - by Dr. J Foerster - 26-04-2016, 11:13 AM
RE: SIS input tables active in DF2 without the H module - by P Herwig MSc - 10-05-2016, 09:38 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)