This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
E610/7 occurs in a calculation
02-05-2016, 04:29 PM, (This post was last modified: 13-05-2016, 01:16 PM by shaswin.)
#1
E610/7 occurs in a calculation
I have a pipeline with local a diameter of 2463 mm and a wallthickness of 531.5 mm (local stiffened rings to influence positive ovalisation in the pipe at the miter bends). The diameter/wallthickness ratio is 2463/531.5 = 4.634
This is lower then 5, so no calculation is done for DF 6.1. According to the changelogs this error check is new in v4.4.0.

Better is to do also 3D stress calculation for thick-walled pipes (Dgem / d < 20, see article 8.5.2.1 NEN 3651:2012) given by this formulae:
   
(Source: D.3.1.1 NEN 3650-2:2012)

Ple4Win does only a 2D stress calculation with this formulae, which is normal for thin-walled pipes (Dgem /d ≥ 20, see article 8.5.2.1 NEN 3651:2012):
   
(Source: D.3.1.1 NEN 3650-2:2012)

A wish is to give a warning instead of an error for the hardcoded limit Diam/wallth < 5 for a 2D stress calculation, because in the previous version v4.3.1 this was allowed or allow a 3D stress calculation given by the first formulae above. As a workaround I have to calculate this project with Ple4Win v4.3.1.

I have addded the project file for this case.


Attached Files
.zip   BC4.zip (Size: 1.23 MB / Downloads: 1)
Reply


Messages In This Thread
E610/7 occurs in a calculation - by shaswin - 02-05-2016, 04:29 PM
RE: E610/7 occurs in a calculation - by shaswin - 09-08-2016, 10:51 AM
RE: E610/7 occurs in a calculation - by shaswin - 26-08-2016, 08:14 PM
RE: E610/7 occurs in a calculation - by shaswin - 18-10-2017, 12:03 PM
RE: E610/7 occurs in a calculation - by shaswin - 06-11-2017, 12:15 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)