This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
SIX and SIF factors in BENDFAC table
29-01-2017, 09:56 PM, (This post was last modified: 29-01-2017, 10:03 PM by shaswin.)
#1
SIX and SIF factors in BENDFAC table
When rerounding due to internal pressure is taken into account the loadfactor PRESS-F shouldn't be applied here. It will reduce the SIX and SIF factors.
   
Press should be 1.00 MPa instead of 1.15 MPa. This makes the SIX and SIF more safer.

I have a question about how the K, SIX and SIF are calculated in the 'General' Option. When I manual calculate with the following formulaes another values are calculated then the Educational version. I can't reproduce it the SIX and SIF in the 'General' Option:

   

   

I have to do some SIX and SIF corrections due to miter bends.


Attached Files
.zip   Test Edu.zip (Size: 195.4 KB / Downloads: 2)
Reply


Messages In This Thread
SIX and SIF factors in BENDFAC table - by shaswin - 29-01-2017, 09:56 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)