This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Stiffenring/Verstijvingsring
24-11-2009, 10:05 AM, (This post was last modified: 24-11-2009, 10:09 AM by Richard.)
#1
Stiffenring/Verstijvingsring
How should a stiffnessring be inputted in the model , without having problems concerning the diameter/wallthickness ratio?

I tried the following method without result:
  • Use a element with a length equal to the width of the ring.
  • Wallthickness (t) in this element is equal to body-radius of the ring.
  • Diameter (D) is equal to the outer diameter of the ring.

This configuration give the folowing error: "diameter/wallthickness-ratio to large". This is an clear error, because a pipeline with these values will not behave like a thinwalled construction.


Messages In This Thread
Stiffenring/Verstijvingsring - by Richard - 24-11-2009, 10:05 AM
RE: Stiffenring/Verstijvingsring - by shaswin - 24-11-2009, 10:14 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)