This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
24-11-2009, 10:14 PM, (This post was last modified: 24-11-2009, 10:18 PM by shaswin.)
RE: Stiffenring/Verstijvingsring
The normal ratio is between 20 and 200. This ratio can be viewed in the PIPEDIM output table.

If the ratio exceeds 200 or is lower then 20 the program will give a warning W310/1.

If you are doing a NEN3650 calculation, there is also a minimum nominal wallthickness criteria (for transport). According to the NEN3650 a lower nominal wallthickness is not allowed, Ple4Win will give you a warning W310/4.

Messages In This Thread
Stiffenring/Verstijvingsring - by Richard - 24-11-2009, 10:05 AM
RE: Stiffenring/Verstijvingsring - by shaswin - 24-11-2009, 10:14 PM

Forum Jump:

Users browsing this thread: 1 Guest(s)