This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
W+WD/D-M in RMAXNEN or RDPLMX
23-03-2017, 12:54 PM,
#1
W+WD/D-M in RMAXNEN or RDPLMX
The maximum change of diameter (in %) W+WD/D-M due to loads in the cross-section is calculated in output tables RMAXNEN or in RDPLMX.

The question is D here the outer or the average diameter. The average diameter is the correct one for thickwalled pipes. It is better to use the average diameter.

If the average diameter is used, please make it more clear in the helpfile in the data description/result options area of the output tables RMAXNEN and RDPLMX.
Reply


Messages In This Thread
W+WD/D-M in RMAXNEN or RDPLMX - by shaswin - 23-03-2017, 12:54 PM
RE: W+WD/D-M in RMAXNEN or RDPLMX - by shaswin - 13-07-2017, 12:34 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)