This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
W+WD/D-M in RMAXNEN or RDPLMX
13-07-2017, 11:56 AM,
#4
RE: W+WD/D-M in RMAXNEN or RDPLMX
In our discussion "normal" thin-walled steel pipelines, plastic pipelines and thick-walled steel pipelines will be considered.
The result might be something like 'use average diameter except if...', but we'll see.
Reply


Messages In This Thread
W+WD/D-M in RMAXNEN or RDPLMX - by shaswin - 23-03-2017, 12:54 PM
RE: W+WD/D-M in RMAXNEN or RDPLMX - by shaswin - 13-07-2017, 12:34 AM
RE: W+WD/D-M in RMAXNEN or RDPLMX - by Dr. J Foerster - 13-07-2017, 11:56 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)