This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
BENDPAR calculation
23-03-2017, 12:59 PM,
#1
BENDPAR calculation
Ref: Tables Reference > Output Tables > Pipe dimension data [PIPEDIM] / ID: H310522

Ref: Design Functions > 5. Pipeline Behaviour [CALPIPE] / ID: H5003

   

Is t here the minimum or the nominal wall thickness of the bend. It is not clear. Is r here also the half of the outer or average diameter.

Please change these in the description in the helpfile.
Reply


Messages In This Thread
BENDPAR calculation - by shaswin - 23-03-2017, 12:59 PM
RE: BENDPAR calculation - by Dr. J Foerster - 12-07-2017, 11:25 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)