This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Horizontal and vertical scaling Pipeline Overview
10-06-2017, 09:51 PM, (This post was last modified: 10-06-2017, 10:05 PM by shaswin.)
#1
Horizontal and vertical scaling Pipeline Overview
Hello,

Is it possible to add an extra checkbox in the Pipeline Overview panel for using the same scale for the horizontal and vertical plane, so that for example the arc length of a bend is drawn in the same scale in the selected horizontal and vertical plane in the Pipeline Overview.

See example below; you see that the horizontal plane is stretched too much in relation with the vertical plane.

   

Thanks


Attached Files
.zip   Pipeline overview.zip (Size: 167.54 KB / Downloads: 1)
Reply


Messages In This Thread
Horizontal and vertical scaling Pipeline Overview - by shaswin - 10-06-2017, 09:51 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)