This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Error in calculation DEADW
06-10-2017, 10:13 AM,
#4
RE: Error in calculation DEADW
Error 310/11 should only occur if there are "No" and "Yes" values in the WLEVEL column (which is not the case in your project, so DEADW tests okay and DF3.1 finishes without error).

For clarity: If there is a "Yes" value anywhere in the WLEVEL column (as in your case with the last row), the whole DEADW table is treated as above water/under water data. In that case it is not possible to define steps in deadweight.
Reply


Messages In This Thread
Error in calculation DEADW - by shaswin - 04-10-2017, 05:00 PM
RE: Error in calculation DEADW - by shaswin - 06-10-2017, 09:36 AM
RE: Error in calculation DEADW - by Dr. J Foerster - 06-10-2017, 10:13 AM
RE: Error in calculation DEADW - by shaswin - 06-10-2017, 10:43 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)