This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Packing factor fm used in the calculation RVT soil parameter
19-12-2017, 01:19 PM,
#1
Packing factor fm used in the calculation RVT soil parameter
According to the helpfile, see screenshot below fm = 0.3 is used in the case no value is filled in.
   

According to the NPR 3659 and the document 'Integraal ontwerp leidingen en riolen, Grondmechanische randvoorwaarden' from GeoDelft the following conclusion has been made and formulae is given (which is also given in the NPR 3659):
   

In the NPR 3659 the following is quoted:
   

I have done some Excel calculations for fm, see screenshot below.
   

This means that for peat/clay soil the fm may be too conservative. It would be nice to use the formula for fm in the Soil Model Wizard, where the phi is averaged over range from ground level to top of pipeline in the case no value is given for fm.
Reply


Messages In This Thread
Packing factor fm used in the calculation RVT soil parameter - by shaswin - 19-12-2017, 01:19 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)