This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Design factor for internal pressure
16-12-2008, 11:42 AM, (This post was last modified: 12-01-2013, 09:03 AM by shaswin.)
#1
Design factor for internal pressure
Hi,

Is it possible to add the design factor for internal pressure (load case 2) in the load case table.

The design factor 1,25 (for internal pressure) is hardcoded in PLE.

In Rotterdam we use according to the Handbook higher values.
We cannot change this value in PLE.

Thanks
Reply


Messages In This Thread
Design factor for internal pressure - by shaswin - 16-12-2008, 11:42 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)