This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Warning about Vertical Profile Data [PROFILE]
11-08-2009, 03:43 PM,
#1
Warning about Vertical Profile Data [PROFILE]
-Q. When I try to run the Soil Wizard, the warning as displayed below arises and the Wizard will not start.
   

-A. Most likely no Ground level [G-LEVEL] table was provided.
Because no Ground level [G-LEVEL] (and (Ground) water level [W-LEVEL]) tables are provided as input tables for design function 2.0, the output table Vertical Profile Data [PROFILE] will remain empty after processing the design function. Since the Soil Wizard is about soil, the Ground level [G-LEVEL] table must be populated. (The (Ground) water level [W-LEVEL] table is optional, however please note that ground water may have influence on the soil parameters.)


Forum Jump:


Users browsing this thread: 1 Guest(s)