This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Horizontal construction subsidence
24-06-2010, 04:23 PM, (This post was last modified: 24-06-2010, 04:24 PM by shaswin.)
Horizontal construction subsidence
Currently Ple4Win allows you to input only vertical construction subsidence.

According to NEN3650-1:2003 Table C.3 subsidence can also occur in the horizontal direction of the pipeline.

Is it possible to extend this with LEFT, RIGHT, BLOCK and DOUBLE subsidence.
30-06-2010, 11:33 AM,
RE: Horizontal construction subsidence
We assigned ticket number 945 to this request.

We will look into this issue and will then consider whether to expand the input options for subsidence or not.
30-06-2010, 11:38 AM, (This post was last modified: 30-06-2010, 12:06 PM by shaswin.)
RE: Horizontal construction subsidence
A practical example:
When you remove a sheet pile near a pipeline a subsidence in horizontal direction may occur.
BLOCK subsidence and SINE LEFT/RIGHT should be taken into account. But this is not yet possible.

Forum Jump:

Users browsing this thread: 1 Guest(s)