This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Extend buckling check in horizontal plane
22-07-2010, 07:23 PM, (This post was last modified: 23-07-2010, 07:54 AM by shaswin.)
Extend buckling check in horizontal plane
When there is a nearby trench parallel with the pipeline, horizontal buckling of the pipeline may occur (depending on the length of the trench). This is the case when there is for example a minimum horizontal soil cover.

Is it possible to add a check for buckling in the horizontal plane?

Module Z could be extended.

Currently Ple4Win assumes KLH and RH are the same on both sides (continuum layer) of the pipeline. This might not be the case when there is minimum horizontal soil cover (within the influence area).

Is it possible to extend KLH and RH with a second KLH and RH input table. When only one of them is filled, Ple4Win should assume that they are then the same on both sides of the pipeline.
15-09-2010, 10:42 AM,
RE: Extend buckling check in horizontal plane
This request has been filed as ticket no. 987.

Forum Jump:

Users browsing this thread: 1 Guest(s)