This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Independent GROUPS input table
16-03-2011, 12:44 PM, (This post was last modified: 16-03-2011, 09:31 PM by shaswin.)
#1
Independent GROUPS input table
Is it possible to remove the GROUPS input table outside the PLE functions. Sometimes you want to add an extra group after a complete PLE calculation.

A user have to set back to function 2 to add extra groups. So all functions must be calculated again and it is certainly time consuming.

I think that this table isn't really used in the calculations. It is only to view special rows.

Possible solution:
A user have to click a button so that the Menu toolbar are updated with the latest added user defined groups (without calculating the whole system again). There must be check for the used idents/ax-lp/ax-l/node/elem are valid when updating the menu toolbar with the user defined groups.
Reply
20-04-2011, 01:57 PM,
#2
RE: Independent GROUPS input table
This request has been assigned ticket no. 1027.

We will look into it, however, this might imply a fundamental change "under the bonnet". So far, all input data (tables) are bound to a design function. They have to be part of a DF, otherwise e.g. testing is not possible. Furthermore, there is currently no place to store/show DF-independant tables.

We will take your suggesting into account. We normally do not encounter your situation very often. Most of the times DF2 has to be recalcuated a couple of times to get all groups right (which is quick). Afterwards, there is no need to change the groups as all of the "interesting points" are known once the pipeline is modeled.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)