This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
implosion
14-03-2012, 05:34 PM,
#1
implosion
Hallo,

where could I find the initial ovalisation of the pipe, which is in the chapter D.3.3.4.1 of NEN3650-2?

Is there an output table for that parameter?

Thanks.
Reply
10-05-2016, 02:51 PM,
#2
RE: implosion
In D.3.3.4.1 of NEN 3650-2:2012 it is no matter of initial ovalisation of the pipeline, but initial eccentricity of the pipe as a beam (f0), also called imperfection.

There is a reference to D.3.3.3.1, where the critical butt value is given.
This value is dependent on the occurring ovalisation, that is reported by PLE in output table RDPLMAX (General) or RMAXNEN (NEN 3650 option). PLE gives a warning if the critical value is exceeded.

There is no possibitity for input of an initial ovalizsation in PLE.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)