RE: Load factor table for internal pressure (load case 2 NEN3650)
The calculation procedure is the same as the NEN3650 except you have higher load factors for primary loads.
The only difference between a Rotterdam and NEN3650 calculation is in the LOAD CASE and SUPPORT ANGLE table:
 Load factor internal pressure is changed from 1,25 to for example 1,88 (it is yet not possible to modify this in Ple4Win in the NEN3650 option module);
 Load factor for PRESSF (LC4) is changed from 1,15 to for example 1,88;
 Load factor for DEADWF is changed from 1,1 to for example 1,88;
 Load factor for NODALF forces is changed from 1,1 to for example 1,88;
 ANGMIN in support angle table is changed from 70 to 90 degrees.
