This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Tabel of deadweight
30-08-2012, 03:59 PM,
#1
Tabel of deadweight
hi,

During the input procedure of deadweight tabel, it is always be a tuff job to fill in the deadweight of various pipes, especially the water level is present. The deadweight jump between above/under water level could only be realized by a jump of node/ax-lp etc. It takes a lot of energy to do it if the calculated system is large, which contains a lot of nodes.

Is it possible that the deadweight tabel works just as Wall thickness tabel? The jump could be realized by the same identifier?

regards
31-08-2012, 08:46 AM, (This post was last modified: 31-08-2012, 08:46 AM by shaswin.)
#2
RE: Tabel of deadweight
Peipei,

I already did a wish for this matter, see this link.
24-01-2013, 11:08 AM,
#3
RE: Tabel of deadweight
Both requests have indeed a lot in common. With one of the future versions of the program we will change the behaviour of the deadweight table. As mentioned in the other forum thread, this request has been assigned ticket no. 1128


Forum Jump:


Users browsing this thread: 1 Guest(s)