This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Calculation internal pressure for thick-walled pipes
31-12-2012, 03:35 PM,
#2
RE: Calculation internal pressure for thick walled pipes
It should be noticed that the formulae for the hoop stress are given for the so-called 'simplified' strength calculation. In general NEN 3651:2012 paragraph 8.3.1 refers to NEN 3650 parts 1 to 5 for the (hoop) stress calculation, where only the formula for the thin-walled pipe is given.

The formula for the thick-walled pipe changes to the formula for the thin-walled pipe if D/d approaches infinity.
Originally PLE has been developed for the strength and stability calculation of 'thin-walled' pipelines.
The hoop stress calculation in the NEN 3650 module is based on NEN 3650-2:2012. Nevertheless it is always good to apply a more accurate formula.

Thank you for your remark.
Reply


Messages In This Thread
RE: Calculation internal pressure for thick walled pipes - by ir KW Radder - 31-12-2012, 03:35 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)