This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Copying TYPE from TEESPEC to Excel
18-02-2013, 03:28 PM,
#1
Copying TYPE from TEESPEC to Excel
Version: Ple4Win Professional 4.2.2 build 12120

When you copy the input table TEESPEC from Ple4Win to Excel the name will be different in Excel.
   

The TYPE is given in the legacy PLE3 names when it is copied into Excel.

Ple4Win (ShortName) => Excel
Reinforced => REIN
Welded => WELD
...
27-02-2013, 01:06 PM,
#2
RE: Copying TYPE from TEESPEC to Excel
If you export the table, then the correct types are shown. With copy-and-paste actions from Ple4Win to Excel the original short names are used.
This is to motivate users to buy the Export module Tongue
Actually, it isn't, it is a bug in the copy-and-paste functionality Undecided
It is the same bug already mentioned in this thread. Therefore this issue is handled together with ticket no J-364.
21-03-2016, 01:51 PM,
#3
RE: Copying TYPE from TEESPEC to Excel
This issue was resolved in 4.3.0.


Forum Jump:


Users browsing this thread: 1 Guest(s)