This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Wish for output table
22-02-2013, 10:17 AM,
#1
Wish for output table
Hi,

I noticed that most of output tables are given in nodes or elements. This gives inconvenience if the user would like to find the information about the component which is already defined in POLYDIF, especially when there are planty of these certain components.

It would be nicer if all the output tables have an extra colomn which gives all the idents which are already defined in POLYDIF. It will cost much less energy to search the node of interesting points and then find the corresponding information at the node/element.

This idea comes out from a recent project which forcus on the force, moment and stress at all the defined flang idents, which cost me a lot of time searching all the corresponding nodes.

regards,
Reply
27-02-2013, 12:35 PM,
#2
RE: Wish for output table
The "Identification names" (IDENTS) table in design function 2 does give you a complete list of node numbers of idents.
However, you idea might speed things up a bit if you are looking for specific idents. We added your idea to our internal wish list, we assigned ticket no J-373 to this issue.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)