This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
SOILSUP / LAMBDA horizontal support angle
13-01-2014, 10:25 AM, (This post was last modified: 13-01-2014, 12:37 PM by shaswin.)
#1
SOILSUP / LAMBDA horizontal support angle
In Ple4Win the angle 120 degrees is fixed in the source code. Is it possible to move the fixed angle 120 degrees as an input angle in the SUPANG input table?

According to the helpfile the factor 0.866 (=SIN(120)) is a fixed value:

Ref: Tables Reference > Output Tables > Cross-sectional loading data [CSLOAD] > Data description/Result options / ID: H620511
   
Ref: Tables Reference > Input Tables > Horizontal soil support / Vertical soil load [LAMBDA] / ID: H610132
   
Ref: Tables Reference > Input Tables > Horizontal soil support pressure [SOILSUP] / ID: H610152
   

I have some situations where the horizontal support angle gamma can be greater then 120 degrees if we do a vertical projection of the horizontal support angle 120 degrees for example for hot pipelines (PE-PUR-steel). The angle is greater then 120 degrees on the steel pipe due to the projection. The moment coefficients and deflection coefficients can be calculated according to the 'Geo-Tubomechanica':

   

f(alpha,beta)=f(gamma,gamma)
Reply
09-06-2015, 07:30 PM, (This post was last modified: 11-06-2015, 01:56 PM by shaswin.)
#2
RE: SOILSUP / LAMBDA horizontal support angle
0.866 should be variable when it is moved from from the fixed code. More reason to apply this is given here.
Reply
11-06-2015, 03:07 PM,
#3
RE: SOILSUP / LAMBDA horizontal support angle
In most cases it is relatively easy to re-calculate values if the actual horizontal support angle is not 120 degrees.
We discussed this issue in the past and then decided to give it a low priority. However, there are discussions going on to increase its priority. Your wish and remarks are fuelling those discussions...
So, this wish is part of our to-do list, for this forum I assigned ticket no J-1733 to it.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)