This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
SWEIGH factors for cast iron ("gietijzer")
05-08-2014, 07:34 PM, (This post was last modified: 05-08-2014, 07:42 PM by shaswin.)
RE: SWEIGH factors for cast iron ("gietijzer")

This knowhow should also be included in the helpfile of PLE (upcoming version Ple4Win v4.3.0).
Three examples can be given:
- the two discussed examples from post #1: PE and nodular cast iron;
- the axial and tangential factors are 1 for steel.

Messages In This Thread
RE: SWEIGH factors for cast iron ("gietijzer") - by shaswin - 05-08-2014, 07:34 PM

Forum Jump:

Users browsing this thread: 1 Guest(s)