This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
SWEIGH factors for cast iron ("gietijzer")
04-12-2014, 04:57 PM, (This post was last modified: 10-12-2014, 03:36 PM by shaswin.)
#6
RE: SWEIGH factors for cast iron ("gietijzer")
Bas, I have made a screenshot of the SWEIGH table (PE 100 pipe with miter bend) for you.

   

In this case Ident "recht1" and "recht2" are straight pipes.
"bocht_s" is the start of the miter bend and "bocht_e" is the end of the miter bend.

0.542 = 0.75/0.9 * 0.65 (within the miter bend; see more information about the factor in this topic)
This reduction is only valid for pure out of plane bends (not valid for sleeping miter bends).


Messages In This Thread
RE: SWEIGH factors for cast iron ("gietijzer") - by shaswin - 04-12-2014, 04:57 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)