This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Omission in interpolation calculation Z_GROUND in PROFILE table
22-08-2014, 09:26 AM, (This post was last modified: 22-08-2014, 01:01 PM by shaswin.)
#2
RE: Omission in interpolation calculation Z_GROUND in PROFILE table
Another example:

IDENT D20B1s: node 10, Z_GROUND PLE: 1641 mm, AutoCAD: 1621.6 mm
IDENT D20B1e: node 20, Z_GROUND PLE: 1496 mm, AutoCAD: 1475.2 mm
IDENT D20B2s: node 24, Z_GROUND PLE: 1176 mm, AutoCAD: 1169.9 mm
IDENT D20B2e: node 28, Z_GROUND PLE: 1148 mm, AutoCAD: 1148.5 mm
IDENT D20B3s: node 37, Z_GROUND PLE: 1767 mm, AutoCAD: 1762.5 mm
IDENT D20B3e: node 43, Z_GROUND PLE: 2000 mm, AutoCAD: 2000.0 mm

There is also difference in this example.

Column W_LEVEL in the PROFILE table is also affected with the same error.


Attached Files
.zip   example2.zip (Size: 167.75 KB / Downloads: 4)


Messages In This Thread
RE: Omission in interpolation calculation Z_GROUND in PROFILE table - by shaswin - 22-08-2014, 09:26 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)