This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Membrane stress calculations not always necessary
06-05-2015, 02:22 PM,
#1
Membrane stress calculations not always necessary
Affected version: Ple4Win v4.3.1 build 15032

Ple4Win does also calculate in the NEN 3650-2 Analysis type the membrane stresses in a pressureless system calculation. According to the NEN 3650-2:2012 article D.3.1.3 this should be done if the loadfactor of the internal pressure is applied (> 0) with BC 3 (no temperature loading).

   

   
Reply
08-06-2015, 02:23 PM,
#2
RE: Membrane stress calculations not always necessary
I moved this thread to the correct sub-forum, a full reaction will follow soon...
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)